Dear friends,

I have a problem with ventilator Drager Fabius, appears the message "ventilator Inop".

Someone can help me?

Best regards.

SWITCH MACHINE OFF AND ON AGAIN, SEE IF THAT WORKS.
IF NOT YOU HAVE A PROBLEM WITH MACHINE STARTING IPPV MODE. PROBLEM USUALLY FOUND IN ELECTRONICS.

You have to read the error address on Fabius CE :
- Press menu key
- Select configuration by turning control knob
- Select 1 by turning control knob
- Push the control knob to confirm
- Push the control knob one more time
See the error code and inform me
I will advice you which parts is defective.

dear, friends

I have a problem on Fabius anaesthesia machine, Error fault "Expiratory valve inop". pls help do i need to replace the expiratory valve.

thanks in advance

Dear Geooff hannis, and friend

I'm working with GE DASH 3000 patient monitor, I'had a problem on it's das 3000 assembly NIBP malfunction, and the display keeps on re-booting, is there any solution to deactivate the NIBP circuit so that it can be use in ECG,SPO2, Temp monitoring thanks in advance

Dennis
This thread is for the Drager Fabius.
You should really start a new thread for the Dash 3000.

Hi, All friends
I want to buy fully bellows for Dreger anesthesia Fabius GS .
Where to find .

Thanks,

Dear Gouw,

Yes, I have a problem with ventilator Fabius CE, appears the message "ventilator Inop".
I did exactly as you say but I do not see the error code.
Only one parameter table as attach file.
Pls help me!

Limk.

Dears Mofe and Limk. Send me your email to hugo_68@yahoo.com
I can send your Service manual.

Thanks for your reply,
Please send me: limk.medical@gmail.com