Home Articles Downloads Forum Products Services EBME Expo Contact
Previous Thread
Next Thread
Print Thread
Rate Thread
#64992 08/06/13 9:40 AM
Joined: Apr 2005
Posts: 371
Laiq Offline OP
Sage
OP Offline
Sage
Joined: Apr 2005
Posts: 371
Dear all.
I am facing error 160 in force fx-8c. all fets, diodes & power mosfet ok.
Any help will b appreciated. thanks in adv.
Laiq

Laiq #64993 08/06/13 11:18 AM
Joined: Feb 2004
Posts: 14,362
Likes: 26
Super Hero
Offline
Super Hero
Joined: Feb 2004
Posts: 14,362
Likes: 26

Can we assume that you have the manual, my friend?

It talks a lot about ECON. boggle


If you don't inspect ... don't expect.
Joined: Apr 2005
Posts: 371
Laiq Offline OP
Sage
OP Offline
Sage
Joined: Apr 2005
Posts: 371
Yup i have it

Laiq #65002 11/06/13 11:31 AM
Joined: Sep 2009
Posts: 132
Expert
Offline
Expert
Joined: Sep 2009
Posts: 132
Hi Laiq.
I have service manual schematic diagrams for this machine.
I will share it to you if you need.
Please contact me via email: Hieuvthospital@gmail.com

Joined: Aug 2007
Posts: 306
Master
Offline
Master
Joined: Aug 2007
Posts: 306
Book says Calibrate ECON factor. Refer to section 5-34.

If alarm reappears, refer to correcting T_ON ASIC Malfunctions. (6-19), which refers to seating IC U9 on the control board, fails again after all this change the U9 chip (Programmable IC)

Hope this helps

Joined: Apr 2005
Posts: 371
Laiq Offline OP
Sage
OP Offline
Sage
Joined: Apr 2005
Posts: 371
Dear All
I have tried removing battery. Machine Still showing Error160. I have replaced other working control board. There was no Error, it booted normally.
I shorted C10 after that now machine showing Error160 & Error212.
I will try to calibrate again. But it means there is problem in Control board. Any guidance or help. where to look.

Joined: Apr 2007
Posts: 3
Newbie
Offline
Newbie
Joined: Apr 2007
Posts: 3
Please check rectifier of FET PCB, replace if faulty then calibrate ECON factor as per manual.
shyam


Moderated by  DaveC in Oz, RoJo 

Link Copied to Clipboard
Who's Online Now
2 members (Stargolf, Dustcap), 111 guests, and 14 robots.
Key: Admin, Global Mod, Mod
Newest Members
Carl Read, DarrenRai, Arasli, qrzdx?, nealzal
9,883 Registered Users
Forum Statistics
Forums25
Topics10,792
Posts72,576
Members9,882
Most Online5,980
Jan 29th, 2020
Powered by UBB.threads™ PHP Forum Software 7.7.5