EBME Forums Forums Maintenance Technical Assistance IBP Testing for Propaq monitors

Thanks guys. many good wishes to WA.

Hi Guys,

How did you go with testing the IBP on the Propaq?

Ive been attempting to do the same thing but the best I can get is a message indicating that there is an incompatible transducer connected.

Im using the Dynatech 217A simulator.

The WA manual refers to pins A B C D E but I dont seem to be able to relate that to the pins on the Propaq.

Am I just missing the obvious?

Bernie

Ok I Was missing the obvious the pin outs for the connectors are on P117 of the manual.

Ill check the wiring and give it another go in the morning.

Bernie

HI I use a Fluke MPS450 simulator and it works fine on the Propaqs. I dont suppose the wiring of the fluke will be the same as your tester so wont go into it here.
Cheers
Mike

i have a problem in infitron2 co2 monitor.
its not powering up.and as i plug it to 15v power supply gets ofF.
and monitor doesnt on.and when i plug it 16vdc fuse of monitor blown.its original supply is 16vdc..anyone have any idea...
ishtyaq87@yahoo.com
thanks