|
|
|
|
Joined: May 2010
Posts: 2
Newbie
|
OP
Newbie
Joined: May 2010
Posts: 2 |
Hi all,
can somebody help me with a service manual or with error code for an Caleo Incubator? I don't know the exact model but i'll find it today( it's not so new )- i get the following error after power on:
Device Error 40
The red led is ON and also the Yellow LED at AIR stay's ON. ( my email is onkynm@yahoo.co.uk )
Last edited by Onky; 31/05/10 2:10 PM.
|
|
|
|
|
Joined: Apr 2002
Posts: 135
Expert
|
Expert
Joined: Apr 2002
Posts: 135 |
I have seen this error when there has been a problem with a skin temperature probe. After the probe has been removed and the Caleo "rebooted" the alarm does not occur again. I have also seen this error when we perform an overtemperature test, again after switching off the the Caleo, the error is cleared when powered up again. View your error logs for other clues and check all the cables and connections.
New beginning. New location. New adventure. Old grumpy me!
|
|
|
|
|
Joined: Feb 2009
Posts: 1,908 Likes: 18
Hero
|
Hero
Joined: Feb 2009
Posts: 1,908 Likes: 18 |
Onky, I have emailed you the service manual for the Caleo, this is for the new version, hope it contains the information that you require.
I am not Flippant, I am Smart
|
|
|
|
|
Joined: Oct 2007
Posts: 75
Adept
|
Adept
Joined: Oct 2007
Posts: 75 |
Error 40 have seen it in error logs, was advised by drager, if no reoccurance to ignore. manual says its a variables conflic, cause software problem or external interface. Remsdy, switch device off and on again if this does not help proceed as follows. replace WT2 controller PCB.
has paul advised i would remove all external leads and devises and reseat all internal connections, long process but hay ho.
Paul doolan at drager is also helpfull
|
|
|
|
0 members (),
34,171
guests, and
15
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
Forums26
Topics11,263
Posts74,531
Members10,373
| |
Most Online59,530 Apr 30th, 2026
|
|
|
|
|
|