EBME Forums Forums Maintenance Technical Assistance Ohmeda 3740 Pulse oximeter - error codes

Dear Friends,

We are getting the following 2 errors in Ohmeda 3740 pusle oximeters.
1. Test signal DC reference error - service unit.

2. ROM test error low byte - service unit.

What can be the problems ? how to solve this ?

Also i would like to get the technical manual for datex 3740 pulse oximeters , kindly send it to my mail jerrytmathew@yahoo.com.
Thanks, Jerry.

To get rid of the 1st Error you need to plug in to AC Mains.
Its Standard if the Battery has been dis-connected or is U/S
The 2nd looks like an eprom fault.

Its connecetd to the mains & battery is fine , but still the errors persists....

Hi Jerry,

both these failures indicate an SMT board failure. I hope this helps

Please send the technical manual for ohmeda 3740 pulse oxime ter ( jerrytmathew@yahoo.com)

Thanks,

Dear sirs, if possible please kindly send me the Service manual for Ohmeda 3740 pulse oximeter to federica_militello@hotmail.com

your help will be greatly appreciated!
Regards