EBME Forums Forums Maintenance Technical Assistance Calibration of Respical test equipment

We recenty sent our Respical flow/pressure tester back to Braun for calibration (We purchased it from them). Braun now inform us that it needs to be returned to Allied in the States for calibration and that Allied are closed until mid January. - Some Christmas holiday! Last year we were without this for almost 6 months whilst it was away for calibration. Presumably we are not the only department with one of these. What do you do for calibration?

We send ours off also for Cal on an annual basis, i assume thats to the states but i'll check when i'm in work tomorrow.

if your lucky enough to own two of them, there is a cross check procedure in the manual to verify calibration until after the christmas break.

I'll check tomorrow and see if we do send it to the states though.

Hi, Any one have a copy of the user/service manual for the Respical T300?
Thanks and have a nice day.

Regards

Hi Graham. I know its been too long since you have posted something about the Respical. Just trying my luck to see if you still have a copy of the user manual for the Respical? Thanks and have a nice day.

Regards.