EBME Forums Forums Maintenance Technical Assistance Versamed iVent 201 Sensibility problem

Dear Friends:

Does any one have experience with this ventilator that could help me?

A preventive maintenance was carried out and the service kit changed, after which it was calibrated and the VVT and OVT test were performed being aprobatory

But when we put the Ventilator to cicle with the default settings for the warm up process and the trigger in -2, 2 it begins to provide additional breathings, the volume and the pressures are correct but it trigger itself (only when the trigger parameters are changed to -2,5 it begins to cicle normally

and of course it doesn't pass the Funcional verification test in the sensibility part

Any ideas?

Thanks in advance

Hola Diego:

Parece ser un tema de compliance del circuito o una minima perdida del circuto interno/externo, es muiy minima por eso hace autotrigger.

Saludos!!

Its look that you a very small leak in the patient circuit or in the internal tubes, or maybe a compliance problem with the patient tubes, that is the reason for the autotrigger situation

Cheers!!